[Gijs Van der Veen]

Hi Duarte,
Welcome!

I think this is what happens:
When you specify a certain storage capacity (X) in the inputfile, you basically give EnergyPLAN the freedom to use 0 to X storage capacity. Therefore, situations can occur where the system chooses not to use the capacity.

Good luck, let me know if this helps.

[Gijs Van der Veen]

Hi Annelies,

I ran into the same problem but I found the solution. Have a look at the tab:
Central Power Production under Supply.

Hopefully this helps, goodluck!

[Author]

Posts